The CR10 can be installed in a custom cabinet, or in a Mclntosh L72 equipment cabinet.
Every CR10 Remote Control System is special, and can be customized for your particular
needs. Your Mclntosh dealer can assist you in the design of the system configuration. Your
dealer is also prepared to do both the installation and connections for you.
The back cover of this manual folds out to show photographs of the front pane! of
the CR10 and the HR10 hand held remote controller. Fold it out to assist you In locating
and identifying the pushbuttons and displays. The numbers and letters on the
photographs refer to the information that follows.
INSTALLATION
AND
CONNECTIONS
1. AREA INPUT SELECTION INDICATORS
These indicators show what input signal source has been selected for each area.
2. AREA POWER ON INDICATORS
These indicators show which areas are turned on and operating.
3. AREA PROGRAM INDICATORS
These indicators show which area is selected for programming input sources and volume
level.
4. SENSOR
The front panel IR sensor that accepts signals from the HR10 hand held remote controller.
5. % VOLUME
The Volume Level indicator shows the volume levels for each selected area. The indicator
reads from 0 to 99. This number is equal to the percentage of the available volume level.
6. PROGRAM SOURCE
After selecting the area to be programmed, these pushbuttons select the desired pro-
gram input signal.
7. AREA PROGRAMMING FOR SIGNAL SOURCE AND VOLUME
These pushbuttons select the area to be programmed for input SOURCE signal and
desired VOLUME level. This programming can be done either before or after the area is turn-
ed on and operating. After selecting the signal source and desired volume, press the area
POWER switch to turn it ON.
PROGRAMMING AN AREA FOR SIGNAL SOURCE AND VOLUME LEVEL PRIOR TO
TURNING ON THE AREA, MUST BE DONE WITHIN TEN SECONDS AFTER SELECT-
ING THE AREA. IF THE AREA POWER IS NOT TURNED ON WITHIN TEN SECONDS
AFTER MAKING SELECTIONS, OR NO SELECTIONS ARE MADE, THE AREA PRO-
GRAMMING WILL TURN OFF.
8. AREA PROGRAMMING POWER ON-OFF
These pushbuttons turn an area ON or OFF. When any of these pushbuttons are turned
ON, the CR10 will turn on and the front panel will be illuminated, if a PC-1 is connected in
the system, the AC power for the specified area amplifier will also turn on.
CR10
FRONT PANEL
PUSHBUTTONS
AND
DISPLAYS
7
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales