McIntosh WK-3 Manual de usuario descargar pdf (Pagina 38)

OPERATION

How to Operate the AM Tuner

The McIntosh MX132 incorporates an advanced design

AM tuner with many desirable performance features to en-

hance your enjoyment of radio broadcasts. There are four

methods of tuning to an AM broadcast station. These are

Manual, Automatic Preset Review, Preset pushbutton

search and Direct Preset number access with the Remote

Control.

How to tune AM stations Manually

1. Select TUNer with the front panel INPUT A switch or

the Remote Control TUNER pushbutton. Refer to Fig-

ure 30 & 31.

2. Select the AM broadcast band

by pressing the AM push-but-

ton on the front panel or on the

Remote Control.

3. Press a front panel TUNING

Up or Down push-button, or a

SEEK pushbutton on the Re-

mote Control, to select sta-

tions. Press and release the

pushbutton to move from one

station to the next. Press and

hold to move continuously up

or down the broadcast band.

When a station is selected, the

front panel display will indi-

cate (from left to right) station

signal strength from 1 to 9, the

AM station frequency and a

preset number if that station

has been assigned a preset.

Figure 33

Note: AM band indications are in Kilohertz and change

frequency in 10kHz steps.

How to Assign AM Presets

1. To assign an AM preset, tune to the desired AM station

with a TUNING Up or Down pushbutton or a SEEK

Up or Down pushbutton on the Remote Control.

Note: If no AM presets have been assigned, when a PRESET

UP or Down pushbutton is pressed, the front panel

display will indicate NO PRESETS. Refer to figure 32.

2. Momentarily press and release the front panel ENTER

pushbutton. The ENTER pushbutton LED will turn on

and the front panel display will indicate 1 AVAIL-

ABLE, which is the first of 9

preset numbers that can be as-

signed. Refer to figure 33.

Note: Presets are automatically

assigned in order from 1 to

9 on AM.

3. Press and release the front

panel ENTER pushbutton a

second time to activate the

assignment memory. The EN-

TER pushbutton LED will

turn off and the AM station

preset selection will be as-

signed preset number 1, and

stored in memory. The as-

signed preset number will ap-

pear to the right of the station

frequency whenever that sta-

tion is selected.

4. Assign additional station Presets by performing steps 1

through 3 until a total of 9 AM presets have been as-

signed. Each time you assign an additional preset num-

ber, the display will indicate the number of the next

available preset. If all 9 presets are assigned and you

press ENTER, the display will indicate the station se-

lected for preset number 1.

Figure 31

Figure 30

How to Operate the AM Tuner

Figure 32

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 51 52

Comentarios a estos manuales

Sin comentarios

McIntosh WK-3 Manual de usuario Pagina 38

Comentarios a estos manuales

Relacionado con productos y manuales para Teclados numéricos McIntosh WK-3